SDA-CRS+ in the house!

2»

Comments

  • Toolfan66
    Toolfan66 Posts: 17,243
    edited October 2011
    I have the 5.8 and the 2.7 in my boards for the 4.1tl mod!!!
    · Share on FacebookShare on Twitter
  • headrott
    headrott Posts: 5,496
    edited October 2011
    But they are in parallel, and not having the 5.8uF cap bypassing the 2.7 ohm resistor though correct Larry? Or am I mistaken about this?

    Also, do you have the single board CRS's?

    Greg
    Relayer-Big-O-Poster.jpg
    Taken from a recent Audioholics reply regarding "Club Polk" and Polk speakers:
    "I'm yet to hear a Polk speaker that merits more than a sentence and 60 seconds discussion." :\
    My response is: If you need 60 seconds to respond in one sentence, you probably should't be evaluating Polk speakers.....

    "Green leaves reveal the heart spoken Khatru"- Jon Anderson

    "Have A Little Faith! And Everything You'll Face, Will Jump From Out Right On Into Place! Yeah! Take A Little Time! And Everything You'll Find, Will Move From Gloom Right On Into Shine!"- Arthur Lee
    · Share on FacebookShare on Twitter
  • Toolfan66
    Toolfan66 Posts: 17,243
    edited October 2011
    Greg,

    They are in parallel, I have the single boards and dual boards, of course I am using the single boards (well I used all the parts off the single boards to use gimpods boards)

    Here is my thread.
    http://www.polkaudio.com/forums/showthread.php?122119-My-SDA-CRS-Upgrade-Thread
    · Share on FacebookShare on Twitter