TSi 100 Speakers

Trev123
Trev123 Posts: 28
edited February 2011 in Troubleshooting
I have a Onkyo TX-SR608 and when setting up the crossover for these speakers which I have options up to 250hz. It says to check your speakers specs. for best crossover frequency which says 2500hz second order whatever that means. So what do I set the crossover freqency at ?
:)
Post edited by Trev123 on
· Share on FacebookShare on Twitter

Comments

  • nguyendot
    nguyendot Posts: 3,594
    edited February 2011
    You set it to where your subwoofer leaves off, typically 80 or 120hz.
    250hz is the crossover in the speaker, not related to your needs.
    Main Surround -
    Epson 8350 Projector/ Elite Screens 120" / Pioneer Elite SC-35 / Sunfire Signature / Focal Chorus 716s / Focal Chorus CC / Polk MC80 / Polk PSW150 sub

    Bedroom - Sharp Aquos 70" 650 / Pioneer SC-1222k / Polk RT-55 / Polk CS-250

    Den - Rotel RSP-1068 / Threshold CAS-2 / Boston VR-M60 / BDP-05FD
    · Share on FacebookShare on Twitter
  • quadzilla
    quadzilla Posts: 1,543
    edited February 2011
    Exactly. The part about "check your speaker specs" is to figure out where the bottom freuncy reponse is, so that if your speakers only go down to 80 Hz, you don't set the crossover point in your AVR to 50 Hz.
    Turntable: Empire 208
    Arm: Rega 300
    Cart: Shelter 501 III
    Phono Pre: Aural Thrills
    Digital: Pioneer DV-79ai
    Pre: Conrad Johnson ET3 SE
    Amp: Conrad Johnson Evolution 2000
    Cables: Cardas Neutral Reference
    Speakers: SDA 2.3TL, heavily modified
    · Share on FacebookShare on Twitter
  • Trev123
    Trev123 Posts: 28
    edited February 2011
    Thanks for clearing that up guys. My subwoofer is the PSW110.
    · Share on FacebookShare on Twitter