SurroundBar6000 discrete On/Off commands
koberlin1
Posts: 1
I was given the following IR commands from Polk technical support, however they do not translate to any universal remote control system code formats. I need them in HEX and have had a difficult time converting them. Without discrete on/off commands to SurroundBar is very difficult to integrate into a home theater system with "macros". Thanks for any help!
Power(toggle) = 00
Power(on) = 01
Power(off) = 02
Vol Up = 1E
Vol Down = 1F
Mute = 20
Subvol up = 5C
Subvol Down = 5D
Source
1 = 0F
2 = 0E
3 = 0C
!
Power(toggle) = 00
Power(on) = 01
Power(off) = 02
Vol Up = 1E
Vol Down = 1F
Mute = 20
Subvol up = 5C
Subvol Down = 5D
Source
1 = 0F
2 = 0E
3 = 0C
!
Post edited by koberlin1 on
Comments
-
http://www.remotecentral.com/cgi-bin/mboard/rc-discrete/thread.cgi?6143
Look at post 9 see if this helps...
Ron2-channel: Modwright KWI-200 Integrated, Dynaudio C1-II Signatures
Desktop rig: LSi7, Polk 110sub, Dayens Ampino amp, W4S DAC/pre, Sonos, JRiver
Gear on standby: Melody 101 tube pre, Unison Research Simply Italy Integrated
Gone to new homes: (Matt Polk's)Threshold Stasis SA12e monoblocks, Pass XA30.5 amp, Usher MD2 speakers, Dynaudio C4 platinum speakers, Modwright LS100 (voltz), Simaudio 780D DAC
erat interfectorem cesar et **** dictatorem dicere a