-
Re: SRS 1.2 no bass
Push in and hold the PR. All the woofers should extend fully, and begin to retract after 3-5 seconds. I would also check and make sure the sub-bass drive inductors are connected. The large spool indu…1 · -
Re: monitor 12 crossover
No! Do not remove the Polyswitches on those. They're revised. Note how it's shunting the small cap. See Schematic_M12_REV1 · -
Re: Looking for advice on RTA11T's
The RTA-11s have quite a bit of internal bracing. If the cabinets are that beat up, and vibrating, it's possible some of the bracing has broken loose. As for budget constraints, don't skimp…1 · -
Re: Off the Floor
The Monitor 10s were designed to be used on Polk's stands, which raise them about 5-6" off the floor, with a 6 degree rake for time alignment.2 · -
Re: Sda srs 2.3 crossover question. Polyswitch.
S1 is the location. The crossovers are normally attached to the large spool inductor with snap-in nylon standoffs.1 ·
