toolbelt

  • Re: RTI Tweeters

    toolbelttoolbelt
    I ran the Daytons with my RTI4's which crossover at 1900hz and didn't notice any signal dropoff or dead zones. Looking at the Dayton graph, it shows flat output from about 1400hz and up. I …
    ·

  • Re: Radial resistors

    toolbelttoolbelt
    So I should try my soldering iron rather than using my plumber's torch then? :D
    ·

  • Re: RTI Tweeters

    toolbelttoolbelt
    ok so here was the basic procedure. I cut the old sealant around the perimeter of the back of the old tweeter, and twisted it out from the perimeter clasps. Because the Dayton had a thicker flange th…
    ·

  • Re: RTi4 crossovers

    toolbelttoolbelt
    Well to end this thread, although I replaced my RTI4's with a pair of RTIA'3, I was able to rebuild the RTI4's to their original state as follows. -sourced a used woofer to replace my …
    ·

  • Re: RTI Tweeters

    toolbelttoolbelt
    Well I went with the Dayton's (ND25FN-4) and although I thought I would need to slightly modify the faceplate opening for dome clearance, the faceplates actually have a stepped opening which all…
    ·
Avatar