-
You're doing it wrong. (FB Marketplace diy SDA upgrade edition)
I needed to share this. I'm at my parents' house, and decided to look for Polk deals along my route home tomorrow. This one... I mean, sure, I understand bristling at Wuhan/Dayton experimentation. I …6 · -
Re: Documenting: My SDA-1c upgrades from start to finish
Thank you for the ideas, @msg I wondered about putting an air mover in the room, vented outside, and using a leaf blower to stir up as much loose dust as I can to be vented into the world. Air compre…1 · -
Re: A new B for me.
I still love Mortite! - The tweeters are different. Same model, different cast for magnet structure. Looks like one was replaced a looooong time ago. - There are scratches on the interior of the voic…1 · -
Re: A new B for me.
Tweets: Dead one worked with other crossover. PCB: I thought about printing a new board and doing wire point-to-point. I might put that to the top of my costs-me-very-little-but-time list. I might ha…3 · -
Re: Legend Line being discontinued.......?
You can use a technique called vapor smoothing for ABS and ASA filaments. It needs venting, but the results are great. A lot of people use a carbon fiber-infused filament to give prints a textured lo…4 ·
