Schurkey
About
- Username
- Schurkey
- Joined
- Visits
- 80
- Last Active
- Roles
- Registered
- Points
- 320
- Posts
- 1,770
- Badges
- 26
Reactions
-
Re: To strap or not to strap
(Quote) If you improve the ground connection, for example from 3 ohms to 0.1 ohm, you would have a performance improvement for the SDA circuit. Probably audible, although I've never tested to see … (View Post)1 -
Re: Tweeter protection fuse question.
Tweeter protection fuses--are they fast-blow or slow-blow? Whichever they are, you'd want the same style in addition to the same amperage/voltage ratings. (View Post)1 -
Re: 1st gen SDA CRS question
(Quote) I had no idea that the 501 wouldn't support 4-ohm speakers. I had to download the service manual to verify. I thought the 501 was well-regarded. Pity. There's usually three reasons … (View Post)1 -
Re: SDA1C vs. SRS2 Smackdown!
(Quote) (Quote) Been done with apparent success on the SDA 1B/SRS 2 blade/blade. Multi-page thread, doesn't start to get good until you're half-way through. http://forum.polkaudio.com/discussi… (View Post)1 -
Re: Using 18uF instead of 20uF for the crossover mod
(Quote) I thought the entire point of replacing the 16mH (SDA) inductor was to drop the DCR in order to improve bass response. The SDA inductor allows the SDA drivers to assist with bass in-phase … (View Post)1
