OEM Blade/Pin SDA cable

Options
tfulton7
tfulton7 Posts: 2
in Vintage Speakers
i am looking for a Polk Audio SRS 3.1 blade/pin interconnect cable. Would appreciate the help locating a cable.
· Share on Facebook

Comments

  • F1nut
    F1nut Posts: 52,406
    edited August 13
    Options
    For an original keep checking eBay.

    A lot of us get rid of the pin/blade cable and sockets. We replace with high quality speaker cable and Neutrik SpeakOn connectors/sockets. There's plenty of info here on that.
    · Share on Facebook
  • tfulton7
    tfulton7 Posts: 2
    Options
    Thanks, where can i go to figure out how to replace the pin/blade
    · Share on Facebook
  • billbillw
    billbillw Posts: 8,286
    Options
    Search at the top for SDA Speakon. It should give you lots of information. Here is one post from one of our most respected SDA mod guys, RIP sadly.
    https://forum.polkaudio.com/discussion/comment/2208422#Comment_2208422
    · Share on Facebook
  • audioluvr
    audioluvr Posts: 6,079
    Options
    I believe the signal is only sent via the pin so you could use a single strand of good quality copper speaker wire and install a good quality banana terminal. Don't quote me on this as I'm sure someone on here will correctly profusely if I'm wrong.
    Gustard X26 Pro DAC
    Belles 21A Pre Upgraded with Mundorf Supremes
    B&K M200 Sonata monoblocks refreshed and upgraded
    Polk SDA 1C's modded / 1000Va Dreadnaught
    Wireworld Silver Eclipse IC's and speaker cables
    Harman Kardon T65C w/Grado Gold. (Don't laugh. It sounds great!)

    There is about a 5% genetic difference between apes and men …but that difference is the difference between throwing your own poo when you are annoyed …and Einstein, Shakespeare and Miss January. by Dr. Sardonicus
    · Share on Facebook
  • Unknown
    Unknown
    Options
    This content has been removed.