Are SRS MW6511's the same as CRS+ MW6511's?

Options
jmardy
jmardy Posts: 27
in Vintage Speakers
While removing one of my 6511's from my SRS II's, I slipped with a screwdriver and poked a f(*&ing hole in the rubber surround. I found a similar vintage 6511 on eBay but it's marked CRS+ instead of SRS.
Would it be a direct replacement? Or should I have the surround repaired/replaced?
· Share on Facebook

Comments

  • jmardy
    jmardy Posts: 27
    Options
    Thanks guys. I can't believe I did that. :s
    · Share on Facebook
  • F1nut
    F1nut Posts: 52,406
    Options
    You're not the first and won't be the last.
    · Share on Facebook
  • audioluvr
    audioluvr Posts: 6,079
    Options
    In my youth I did this to one of my SDA drivers. I think I used Shoe Goo or rubber cement to repair it. Held up for years.
    Gustard X26 Pro DAC
    Belles 21A Pre Upgraded with Mundorf Supremes
    B&K M200 Sonata monoblocks refreshed and upgraded
    Polk SDA 1C's modded / 1000Va Dreadnaught
    Wireworld Silver Eclipse IC's and speaker cables
    Harman Kardon T65C w/Grado Gold. (Don't laugh. It sounds great!)

    There is about a 5% genetic difference between apes and men …but that difference is the difference between throwing your own poo when you are annoyed …and Einstein, Shakespeare and Miss January. by Dr. Sardonicus
    · Share on Facebook
  • Tony M
    Tony M Posts: 12,018
    Options
    My neighbor used bicycle tire innertube glue, and he said it worked fine on his B&W speaker surrounds. :#
    Most people just listen to music and watch movies. I EXPERIENCE them.

    “Anger is an acid that can do more harm to the vessel in which it is stored than to anything on which it is poured.”
    --Mark Twain.

    “If at first you don't succeed, then skydiving definitely isn't for you.” - Steven Wright
    · Share on Facebook
  • jmardy
    jmardy Posts: 27
    Options
    Thanks guys. It's a tiny hole. I'll see what I can figure out.
    · Share on Facebook