What model are these speakers, please

Options
cschille
cschille Posts: 2
in Speakers
Inherited them from my father. My mother was using them as plant stands! Looking to match a bluetooth amp.jv0nebo04fue.jpg
· Share on Facebook

Best Answer

  • F1nut
    F1nut Posts: 52,305
    Answer ✓
    Options
    Polk SDA 1A. They are 4 ohm loads, so you need a dedicated power amplifier rated to drive that load.

    Do you have the SDA cable that connects the left and right speakers?

    I know nothing about Bluetooth amps, nor do I care to.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on Facebook

Answers

  • JCL
    JCL Posts: 174
    Options
    If you connect them with the interconnect cable your amp will have to be a common ground amp.
    L600 (front), R200 (rear), R200 (rear surround), L400 (center), Sunfire HRS-10 (2)Marantz AV7706Sunfire Cinema Grand, Marantz M8077, Music Hall Stealth, Ortofon bronze cartridge, Parasound Zphono XRM, Sony UBP-X800
    · Share on Facebook
  • skipshot12
    skipshot12 Posts: 2,127
    Options
    Could be interesting….
    · Share on Facebook
  • Toolfan66
    Toolfan66 Posts: 18,370
    Options
    Not what they look like up close, but they look very clean for being plant stands.
    · Share on Facebook
  • cschille
    cschille Posts: 2
    edited May 2025
    Options
    Thanks for all the info, folks. Alas, I don't have the SDA cable.
    · Share on Facebook
  • pitdogg2
    pitdogg2 Posts: 27,780
    Options
    cschille wrote: »
    Thanks for all the info, folks. Alas, I don't have the SDA cable.

    One tweeter and the dimensional driver will not work without it. So don't go thinking you've got blown drivers.
    The blade/blade cable is still available on ebay, cost about $50-$60.
    · Share on Facebook