Butcher Block table

Options
xschop
xschop Posts: 4,696
in DIY, Mods & Tweaks
Someone in the neighborhood was remodeling and gave me these pieces. I just installed some hair pin legs that Jeff Bezos sent me. I offered to tung -oil them, but wifey wants them bare looking....

1hrrk3yecwou.jpg

lvpl97zdpj1f.jpg

Don't take experimental gene therapies from known eugenicists.
· Share on FacebookShare on Twitter

Comments

  • Clipdat
    Clipdat Posts: 12,600
    Options
    Neat.
    · Share on FacebookShare on Twitter
  • xschop
    xschop Posts: 4,696
    edited March 2022
    Options
    xqzjsb98xrlw.jpg
    Don't take experimental gene therapies from known eugenicists.
    · Share on FacebookShare on Twitter
  • Gardenstater
    Gardenstater Posts: 4,184
    Options
    Are those the Gaia IV vibration isolation feet?
    George / NJ

    Polk 7B main speakers, std. mods+ (1979, orig owner)
    Martin Logan Dynamo sub w/6ft 14awg Power Cord
    Crown D150 amp
    Logitech Squeezebox Touch Streamer w/EDO applet
    iFi nano iDSD DAC
    iPurifier3
    iDefender w/ iPower PS
    Custom Steve Wilson 1m UPOCC Interconnect
    iFi Mercury 0.5m OFHC continuous cast copper USB cable
    Custom Ribbon Speaker Cables, 5ft long, 4N Copper, 14awg, ultra low inductance
    Custom Vibration Isolation Speaker Stands and Sub Platform
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 49,798
    Options
    What, no custom turned aluminum legs!?!
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • pitdogg2
    pitdogg2 Posts: 24,575
    Options
    F1nut wrote: »
    What, no custom turned aluminum legs!?!

    Disappointing....



    😱
    · Share on FacebookShare on Twitter
  • xschop
    xschop Posts: 4,696
    edited March 2022
    Options
    F1nut wrote: »
    What, no custom turned aluminum legs!?!

    Thought I mentioned wifey....
    They're going to her office, and as with most women she changed her mind when I showed her the oil applied on the bottoms for comparison...

    6to2adnr3zi9.jpg
    Post edited by xschop on
    Don't take experimental gene therapies from known eugenicists.
    · Share on FacebookShare on Twitter
  • xschop
    xschop Posts: 4,696
    Options
    Gardenstater wrote: »
    Are those the Gaia IV vibration isolation feet?

    I was trying to incorporate a 1/2" SS ball and 3" cup radius.... No dice 😂
    Don't take experimental gene therapies from known eugenicists.
    · Share on FacebookShare on Twitter
  • skrol
    skrol Posts: 3,338
    edited March 2022
    Options
    rktc48ty4td8.jpeg
    This past weekend I was in Carlisle PA and the near by coffee shop (Denim Coffee) had butcher block tables. Something I noticed was how warped they were getting and the different woods swollen differently. I suspect they were not sealed very well and were subjected to lots of washing.

    Very good espresso drinks at Denim Coffee by the way and very friendly staff.
    Stan

    Main 2ch:
    Polk LSi15 (DB840 upgrade), Parasound: P/LD-1100, HCA-1000A; Denon: DVD-2910, DRM-800A; Benchmark DAC1, Monster HTS3600-MKII, Grado SR-225i; Technics SL-J2, Parasound PPH-100.

    HT:
    Marantz SR7010, Polk: RTA11TL (RDO198-1, XO and Damping Upgrades), S4, CS250, PSW110 , Marantz UD5005, Pioneer PL-530, Panasonic TC-P42S60

    Other stuff:
    Denon: DRA-835R, AVR-888, DCD-660, DRM-700A, DRR-780; Polk: S8, Monitor 5A, 5B, TSi100, RM7, PSW10 (DXi104 upgrade); Pioneer: CT-6R; Onkyo CP-1046F; Ortofon OM5E, Marantz: PM5004, CD5004, CDR-615; Parasound C/PT-600, HCA-800ii, Sony CDP-650ESD, Technics SA 5070, B&W DM601
    · Share on FacebookShare on Twitter
  • audioluvr
    audioluvr Posts: 5,434
    edited March 2022
    Options
    skrol wrote: »
    rktc48ty4td8.jpeg

    That appears to be oak or walnut which is very subject to warping due to it's density. The OP appears to be using Alder which is quite a bit softer. It could be protected by rubbing in a satin water based polyurethane like this:

    ugzq6iv0n1az.png
    Gustard X26 Pro DAC
    Belles 21A Pre modded with Mundorf Supreme caps
    B&K M200 Sonata monoblocks refreshed and upgraded
    Polk SDA 1C's modded / 1000Va Dreadnaught
    Wireworld Silver Eclipse IC's and speaker cables
    Harman Kardon T65C w/Grado Gold. (Don't laugh. It sounds great!)

    There is about a 5% genetic difference between apes and men …but that difference is the difference between throwing your own poo when you are annoyed …and Einstein, Shakespeare and Miss January. by Dr. Sardonicus
    · Share on FacebookShare on Twitter
  • EndersShadow
    EndersShadow Posts: 17,531
    Options
    audioluvr wrote: »
    skrol wrote: »
    rktc48ty4td8.jpeg

    That appears to be oak or walnut which is very subject to warping due to it's density. The OP appears to be using Alder which is quite a bit softer. It could be protected by rubbing in a satin water based polyurethane like this:

    ugzq6iv0n1az.png

    If it’s hard to find that it’s cause he looking in…..


    ALDER wrong places 🤣
    "....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963)
    · Share on FacebookShare on Twitter
  • xschop
    xschop Posts: 4,696
    Options
    ...nookin fa nub
    Don't take experimental gene therapies from known eugenicists.
    · Share on FacebookShare on Twitter
  • Gardenstater
    Gardenstater Posts: 4,184
    Options
    That one cup ......Can't Get No Satisfaction.......(groan)
    George / NJ

    Polk 7B main speakers, std. mods+ (1979, orig owner)
    Martin Logan Dynamo sub w/6ft 14awg Power Cord
    Crown D150 amp
    Logitech Squeezebox Touch Streamer w/EDO applet
    iFi nano iDSD DAC
    iPurifier3
    iDefender w/ iPower PS
    Custom Steve Wilson 1m UPOCC Interconnect
    iFi Mercury 0.5m OFHC continuous cast copper USB cable
    Custom Ribbon Speaker Cables, 5ft long, 4N Copper, 14awg, ultra low inductance
    Custom Vibration Isolation Speaker Stands and Sub Platform
    · Share on FacebookShare on Twitter