WTB: Dreadnought Case (or equivalent)

kickngas · January 13

I have parts on the way, but having a difficult time finding a suitable case like the one Larry used to sell. I am open to suggestions, or an original Larry's case if you are tired of looking at the one you bought with good intentions for building a Dreadnought...and never followed through!😉

pitdogg2 · January 13

what parts you got?

kickngas · January 13

Avel Y236906 should be here Saturday. Researching/Deciding on cable and terminals as we speak.

pitdogg2 · January 13

kickngas wrote: »

Avel Y236906 should be here Saturday. Researching/Deciding on cable and terminals as we speak.

reach out to @westmassguy he may have a case or could point you in a good direction.

kickngas · January 13

Thanks for the advice!

audioluvr · January 14

Go on ebay and search "aluminum box" there's like a zillion of them.

kickngas · January 14

Yeah, but trying to get a specific size sort of limits the selection. I have found a Hammond recommended by a member here that will work just fine.

pitdogg2 · January 14

Yes I couldn't remember the name of the case I had for my 800. Hammond it was. I will say that they fit very tight in there and you really don't need to bolt it to the case because the case actually clamps it between the shells of the top and the rest of the box at least mine did I didn't even have enough room to put any dynamat in it

kickngas · January 14

This one is the Hammond 1550NBK and it is about 10 x 10 x 4. Just realized I haven't ordered it yet

pitdogg2 · January 14

kickngas wrote: »

This one is the Hammond 1550NBK and it is about 10 x 10 x 4. Just realized I haven't ordered it yet

That's about correct. I never measured mine but it was smallish.

ken brydson · January 15

pitdogg2 wrote: »

kickngas wrote: »

This one is the Hammond 1550NBK and it is about 10 x 10 x 4. Just realized I haven't ordered it yet

I never measured mine but it was smallish.

Nope nope nope....

pitdogg2 · January 15

ken brydson wrote: »

pitdogg2 wrote: »

kickngas wrote: »

This one is the Hammond 1550NBK and it is about 10 x 10 x 4. Just realized I haven't ordered it yet

I never measured mine but it was smallish.

Nope nope nope....

Pffft that would require a scanning electron microscope.

Geez jump in with both feet you big sissy 😂😂

msg · January 15

I think I have one of Larry's 1st gen cases in the stash, but it's set up for binding posts, not Neutrik.

msg · January 15

I need reading lessons.

kickngas · January 15

msg wrote: »

I think I have one of Larry's 1st gen cases in the stash, but it's set up for binding posts, not Neutrik.

I already ordered my case or I would have bought yours. I'll bet it would sell fast on the classifieds here.

msg · January 15

Yeah, no sweat. That spare one I have is pre-drilled for binding posts and most people switched over to Neutrik now for current Dread builds, so it's not the first choice anymore.

WTB: Dreadnought Case (or equivalent)

Comments

Howdy, Stranger!

Quick Links