How to fix intermittent failures of surroundbar 3000?

Options
Drichar
Drichar Posts: 2
in Troubleshooting
Hey y'all, I have a surroundbar 3000 that works absolutely amazing when it wants to, but it usually goes out for a week and the works again. Everything is connected well, but every so often the green LED on the rear of the sub starts just blinking and will not link with the soundbar, and the soundbar will not link with my TV so I cannot get any sound at all from it. I know it's old, but it's in mint condition.
· Share on FacebookShare on Twitter

Best Answer

  • F1nut
    F1nut Posts: 49,801
    Answer ✓
    Options
    .45
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter

Answers

  • OleBoot
    OleBoot Posts: 2,122
    Options
    F1nut wrote: »
    .45

    They kill soundbars, don;t they?
    · Share on FacebookShare on Twitter
  • Drichar
    Drichar Posts: 2
    Options
    It worked! You're a genius, thank you!
    · Share on FacebookShare on Twitter
  • BlueFox
    BlueFox Posts: 15,251
    Options
    LOL. Another soundbar troll.
    Lumin X1 file player, Westminster Labs interconnect cable
    Sony XA-5400ES SACD; Pass XP-22 pre; X600.5 amps
    Magico S5 MKII Mcast Rose speakers; SPOD spikes

    Shunyata Triton v3/Typhon QR on source, Denali 2000 (2) on amps
    Shunyata Sigma XLR analog ICs, Sigma speaker cables
    Shunyata Sigma HC (2), Sigma Analog, Sigma Digital, Z Anaconda (3) power cables

    Mapleshade Samson V.3 four shelf solid maple rack, Micropoint brass footers
    Three 20 amp circuits.
    · Share on FacebookShare on Twitter