Polk Audio
›

Speaker Dust Caps

IrrenhausIrrenhaus Posts: 770
in Speakers
Hi All

The dust caps on my Linn's are crumbling down I will order replacements tomorrow. Now what is the best way to remove the old glue?

ls12ohfusq6k.jpg
88gpvmclc468.jpg

Cheers
AVR-Onkyo709
AMP- Parasound 2125, Adcom 585
Mains for HT and some Music- RTi12s
Main for Music only- Linn Keilidh or Usher V-601 and SDA 1C
PreAmp for Music: Cary AE-3
Rear- RT150
Center-CSi5
Sub-Rythmik audio F25
Player- Oppo BDP-103


Bedroom rig:
Pionner Elite VSX-30...Onkyo CS-5VL SACD Player....Polk Audio LS70

Comments

  • FestYboyFestYboy Posts: 3,252
    I'd take an exact-o down to where you're comfortable, then use the remaining glue as a placement guide and glue back in.
  • pitdogg2pitdogg2 Posts: 12,284
    edited December 2018
    I've been very successful at razor x then just peeling the old off. (paper cone) Making sure you hold the cone so you don't pull up over the pole piece. Is the cone and cap plastic? Careful it can be very brittle and cutting very close like @FestYboy suggests might be best
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register

Quick Links

© Polk Audio 2014