Does this look right?

CH46ECH46E Posts: 1,204
Im trying to wire up 3 single voice coil 4 ohm subs on one channel. If i can get 2.7 ohms like this pic shows ill be good to go.

This look accurate? And would all three subs receive the same amount of power? Ok to put them in one ported chamber?



  • FestYboyFestYboy Posts: 3,699
    Ok, so sub 1 and 2 make an 8 ohm load that is then paralleled to another 4 ohm load... To me that becomes something like a 5.x ohm load.

    I could be wrong though.
  • mhardy6647mhardy6647 Posts: 22,963
    It is as the Yboy says in principle, although I think he slipped a digit someplace doin' the arithmetic :(
    Ohm. He is the Law. B)


    Resistances (or Impedances)* in series are additive.
    Rt = R1 + R2 + ...

    Resistances (or Impedances) in parallel follow a rule like this:
    1/Rt = 1/R1 + 1/R2 + ...

    In the illustrated case: R1 and R2 are in series, so Rt for those two is 8 ohms.

    R3 is then wired in parallel to (R1 +R2), so, in this case:

    1/Rt = (1/8 + 1/4)

    1/Rt = 3/8

    Rt = 8/3 = 2.67 Ohms

    * Voice coils passing AC waveforms (music!) are reactive devices and as such the parameter of interest is impedance as opposed to resistance (which applies only to DC circuits or those without inductive or capacitive components). Technically, impedance is called Z and resistance is R, but both quantities obey Ohm's Law :)
  • FestYboyFestYboy Posts: 3,699
    When the doctor speaks, knowledge is bestowed. I neglected the least common denominator (derp).
  • mhardy6647mhardy6647 Posts: 22,963
    Well, you know what they say:
    Give a man a fish, and he is fed for a day.
    Teach a man to fish, and you won't see him for the rest of the weekend.
  • CH46ECH46E Posts: 1,204
    Well, after looking at all the specs for the class d amps i was looking at, i think i just need to source one more driver and make it 4 and just run two 2 ohm loads.

    Thanks for the ohms law lesson!
  • mlistens03mlistens03 Posts: 2,632
    CH46E wrote: »
    Thanks for the ohms law lesson!

    Not Tom or Trey or Jim just Micah
    KEF Q150s, NAD 1155 preamp and 4155 tuner courtesy of DaddyJT, NAD C352 playing power amp, BJC Belden cables, Technics SL3200, Marantz CD6004 courtesy of Clipdat, Salamander Archetype rack, Millenium Falcon :)
    I've always thought the goal of high-end audio was not to have your neighbors bang on the wall and say, 'Turn that darn music down' but to have your neighbors bang on the wall and say, 'Tell your friends to go home and you can practice later this week'.

    Resident Child of Club Polk
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!