LSi25 Crossover problem??

Hi, I have a pair of LSi25´s. One of them needs a new tweeter and the other speaker that has a good tweeter shuts off the tweeter at about half volume and resets it. I believe I need a rebuilt crossover in that speaker? Can anyone please help. Thank you.

Comments

  • KennethSwaugerKennethSwauger Moderator Posts: 6,846
    Hello,
    Replacement crossovers should be available from Polk's CS department, you can telephone them at 1-800-377-7655 or use email [email protected]
    Mention you are a Club Polk member for cost savings.
    Regards, Ken
    "They thought we were too loud, but shoot, I had four army blankets folded over my amp, and the volume level was on 2. I'm used to playin' on 10!" S.R.V.
  • Thank you so much my friend! I will be calling them tomorrow. As I meant to state earlier, I purchased these as demo speakers. They came to me in this condition.
    Thanks again!!!
  • tonybtonyb Posts: 31,642
    edited February 2015
    Thank you so much my friend! I will be calling them tomorrow. As I meant to state earlier, I purchased these as demo speakers. They came to me in this condition.
    Thanks again!!!

    What the guys are trying to get at is....how do you know you need new crossovers ? Did you look at them and see if anything was burnt on the board ? Maybe all you need is a resistor....maybe all you need is a tweeter.....maybe a wire came loose. Do you have them hooked up properly ? Hate to see you buy new crossovers and they still don't work.

    That said, they came to you as demo's from an Audio store ? I would never buy a thing from them again.

    HT SYSTEM-
    Sony 850c 4k
    Pioneer elite vhx 21
    Sony 4k BRP
    SVS SB-2000
    Polk Sig. 20's
    Polk FX500 surrounds

    Cables-
    Acoustic zen Satori speaker cables
    Acoustic zen Matrix 2 IC's
    Wireworld eclipse 7 ic's
    Audio metallurgy ga-o digital cable

    Kitchen

    Sonos zp90
    Grant Fidelity tube dac
    B&k 1430
    Tad 803 speakers
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!