Infinity Kappa Perfect 10.1 Subs

jim 249
jim 249 Posts: 347
edited June 2014 in Vintage Speakers
I am looking at buying a pair of these for my Carver ALIII's as these are highly recommended. They came in two configurations, a single 4 ohm voice coil and a dual 4 ohm voice coil. The pair I found is a dual 4 ohm voice coil. I need a 4 ohm voice coil to match the Carvers. Can the dual voice coil be hooked up to run as 4 ohms? Thanks for any help!
Post edited by jim 249 on

Comments

  • Mr. Bubbles
    Mr. Bubbles Posts: 736
    edited June 2014
    dual 4 ohm coils can be hooked up for either 2 or 8 ohms but not 4 ohms. However there is more to matching speakers to subs than just the impedance.
    If con is the opposite of pro, is Congress the opposite of Progress?!


    Monitor 5Jr, Monitor 5, RTA12, RTA 15TL, SDA 2A, 1c, SRS 2, 1.2TL, CRS, Atrium.
  • Habanero Monk
    Habanero Monk Posts: 715
    edited June 2014
    Can you simply purchase the 4ohm version and return the DV version?
  • villian
    villian Posts: 412
    edited June 2014
    If you run both woofers off one amp, independently of the mids/highs/xovers (Not sure how your speakers are setup) in the speaker cabinets, then you could run both at 4ohms off one amplifier. Just another possibility. ZLTFUL mentioned 4 channels of amplification and that's for both subs combined. So two channels for each sub. One set of +/- to each voice coil on each sub at 4ohms. Just to make sure you understood what he meant.
    Too many good quotes to list..waiting for some fresh ammo. :)
  • WLDock
    WLDock Posts: 3,073
    edited June 2014
    2.2 Office Setup | LG 29UB55 21:9 UltraWide | HP Probook 630 G8 | Dell Latitude | Cabasse Stream Amp 100 | Boston Acoustics VS 240 | AUDIORAX Desk Stands | Sub 1 - Mirage Omni S8 | Sub 2 - Mirage Omni S8

    5.2 A/V Setup | OLED TV - Sony Bravia XR A80J 77" | Source - Fire TV 4K Max, Wiim Pro | AVR - Anthem MRX 520 | Speakers: Main - Boston Acoustics VR3 | Center - Boston Acoustics VR920 | Rear - Boston Acoustics VR-MX | Sub 1 - HSU VTF-2 mk3 | Sub 2 - HSU VTF-2 mk3
  • jim 249
    jim 249 Posts: 347
    edited June 2014
    Thanks for the replies. Won't work. sigh