Using a 4 channel Amp to power a Polk Audio db1040 DVC sub
I have (3) 4 channel amps that have been sitting in the garage for awhile and I've decide that rather than buying yet another new amp I will use one of these to power a sub. When bridged it is rated at 150 x 2 at 4 ohms. If I use Y splitters on the singnal so both sets of bridged inputs and outputs use the same signal is there any reason I should be concerned running a Polk Audio db1040 DVC with one coil using channels 1&2 bridged and the other coil using channels 3&4 bridged? Will this set up void my warrenty?
Post edited by TJeep_1999 on