New Speaker Cable
Just recently, I posted a thread on a positive experience with Douglasconnection.
While I'm waiting to be in a position to pick up some extra parts to finish off my Back Surround cables. I had enough bits and pieces to start dinking around and ended up slapping my center channel cable together.
It's Vampire Wire 13/4 being used in a single application. Take a look at the silver content in the cable;
While I'm waiting to be in a position to pick up some extra parts to finish off my Back Surround cables. I had enough bits and pieces to start dinking around and ended up slapping my center channel cable together.
It's Vampire Wire 13/4 being used in a single application. Take a look at the silver content in the cable;
Post edited by Geoff4rfc on
Comments
-
Why are the cables twisted at one end and not the other?Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
The wires are twisted at both ends. With the obvious twist, the wires still have the individual coverings.
On the other end with the red/black, I stripped the coverings off, twisted the wires, then covered them. -
Nice Job Geoff!
Sunfire Theater Grand IV
Sunfire Cinema Grand Signature
SRS 2.1TL
SDA 2BTL's
CSiA6
FXiA4
FXiA6
SDA 2A's
Monitor 10A's
http://www.douglasconnection.com -
That explains it. :cool:Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
helipilotdoug wrote: »Nice Job Geoff!
Thanks!! I'm looking forward to tackling the 10g using some nice separators!
