Danley DTS-10 arrives
Wardsweb
Posts: 935
My new Danley DTS-10 sub horn arrived yesterday. Now to assemble and work with room placement. Once I know which side will get the horn opening, I will seal the other and veneer the entire thing in Macassar ebony.
Post edited by Wardsweb on
Comments
-
That is insane! Very nice.
-
Conradicles wrote: »That is insane! Very nice.
Nothing exceeds like excess and yes, two 12's in a tapped horn is insane. That's what I like about it. Still, not as insane as when I was running two Bassmaxx B1 18" bass horns. Although the Danley's goes lower, as in 10 hertz.
-
Here is the cabinet assembled.
-
Here are the subs
-
Here it is veneered and almost done with the finish. It will sit on the floor and the Martin Logan CLS are being replaced with Martin Logan Prodigy speakers.
This thing goes really low, like 10Hz. It is very fast, open and airy. I needed that to keep up with the electrostats.
-
Install is complete and my system is now at a whole new level.
-
All I can say is WOW. Very impressive setup, makes mine look like a Fisher Price, lol.
-JeffHT Rig
Receiver- Onkyo TX-SR806
Mains- Polk Audio Monitor 70
Center- Polk Audio CS2
Surrounds- Polk Audio TSi 500's
Sub- Polk Audio PSW125
Retired- Polk Audio Monitor 40's
T.V.- 60" Sony SXRD KDS-60A2000 LCoS
Blu-Ray- 80 GB PS3
2 CH rig (in progress)
Polk Audio Monitor 10A's :cool:
It's not that I'm insensitive, I just don't care..