PSW 202 settings and connecting

mbrasg
mbrasg Posts: 2
edited May 2003 in Subwoofer Hookup & Bass Management
As a newbie to the Polk range I'm VERY impressed with the sound so far.
I'm a bit thick when connecting things together, so please assist here.

I have one sub output on my SRS 595 Receiver. Which port, L or R do I plug into the sub?

Or, do I need to bridge the L and R channels and plug into the bridge?
Post edited by mbrasg on
· Share on FacebookShare on Twitter

Comments

  • faster100
    faster100 Posts: 6,124
    edited May 2003
    yes, you can get a Y adapter sold at circuit city and run a single sub cable from the receivers single sub out to the Y adapter and into the sub L/R,
    MY HT RIG:
    Sherwood p-965
    Sherwood sd871 dvd
    Rotel 1075 amp x5
    LSI15 mains
    LsiC center
    LSIfx surround backs
    Lsi7 side surrounds
    SVS pb12/plus2

    2 Channel Rig:

    nad 1020 Pre-amp
    Rotel 1080 stereo amp
    Polk sda 2B
    kenwood grunt Tuner
    realistic lab 450 TT
    Signal cable IC
    · Share on FacebookShare on Twitter
  • BeginnersLuck
    BeginnersLuck Posts: 213
    edited May 2003
    Or you can run the sub out cable into either the left or the right on the amp to accomplish the same thing without having to buy a y adapter. Using the y adapter will give you a net gain of about 3db. This is not necessary as it will only result in lowering the volume knob on your sub amp...so i would recommend saving the cash...

    Welcome to the forums!
    -BL
    TWFTPQ
    Receiver: Outlaw 1050
    Amps: Outlaw M-200 x 3 (Powering Mains and Center)
    Mains: RT800i; Center: CS400i; Surrounds: F/X500i
    Sub1: 214L Vented Tempest
    Sub2: 122L Sealed Tempest
    · Share on FacebookShare on Twitter