driver question

scottdawg
scottdawg Posts: 166
edited March 2003 in Speakers
Newbie here. First I want to express my admiration of this forum. I am an audiophile born again, being out of the loop for some time I happened upon some M7 series 2 speakers for cheap, My interest has perked again, anyway I bought them and found that one driver is bad. Polk is out of stock for a few weeks and I am dying to get these fixed. There are several MW6500 for sale on e-bay. Whats the difference between the MW6500 and the MW6502. I will be driving these with a Yamaha A-700 amp I picked up while in the navy back in 87, they will be playing alongside a set of JBL L100T's from that same era.
Post edited by scottdawg on
· Share on FacebookShare on Twitter

Comments

  • nadams
    nadams Posts: 5,877
    edited March 2003
    I honestly couldn't tell you.... my Monitor 5's have the 6502s in them. If noone else can answer you here, a call to Polk might be able to help you.

    Welcome to the forum!

    nadams
    Ludicrous gibs!
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,647
    edited March 2003
    Wait a few weeks and get the right driver.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • NINjesse
    NINjesse Posts: 12
    edited March 2003
    ive found that in some instances a simple change of simalar model numbers can equal major component changes. it could be as simple as a cage mod or as major a cone matirial change.
    i would wait for a match, or find out exactly what the difference is.
    · Share on FacebookShare on Twitter
  • scottdawg
    scottdawg Posts: 166
    edited March 2003
    OK, thanks I'll wait
    Scott
    · Share on FacebookShare on Twitter