Clamps with peripheral rings
Ian lane
Posts: 12
Hi everyone
Just wondering if any of you guys with Joe's Clamp have tried it in combination with one of the peripheral ring clamps.
I would be interested to know if there was a significant improvement over the Clamp alone.
Cheers,
Ian
Just wondering if any of you guys with Joe's Clamp have tried it in combination with one of the peripheral ring clamps.
I would be interested to know if there was a significant improvement over the Clamp alone.
Cheers,
Ian
Post edited by Ian lane on
Comments
-
I've thought about this too, but my "The Clamp" presses the vinyl down so flat into my 3mm Herbie's Way Excellent mat that I've so far spent the dough needed for a ring on electronics.VTL ST50 w/mods / RCA6L6GC / TlfnknECC801S
Conrad Johnson PV-5 w/mods
TT Conrad Johnson Sonographe SG3 Oak / Sumiko LMT / Grado Woodbody Platinum / Sumiko PIB2 / The Clamp
Musical Fidelity A1 CDPro/ Bada DD-22 Tube CDP / Conrad Johnson SD-22 CDP
Tuners w/mods Kenwood KT5020 / Fisher KM60
MF x-DAC V8, HAInfo NG27
Herbies Ti-9 / Vibrapods / MIT Shotgun AC1 IEC's / MIT Shotgun 2 IC's / MIT Shotgun 2 Speaker Cables
PS Audio Cryo / PowerPort Premium Outlets / Exact Power EP15A Conditioner
Walnut SDA 2B TL /Oak SDA SRS II TL (Sonicaps/Mills/Cardas/Custom SDA ICs / Dynamat Extreme / Larry's Rings/ FSB-2 Spikes
NAD SS rigs w/mods
GIK panels -
Thanks for your thoughts. It is what I suspect and frankly hope is the case.
Many of the commercial ring clamps need central clamps and vice versa. -
When The Clamp is used properly there should be no need for a periphery clamp.
-
Joe,
I need a lesson in this clamp.
RT1 -
reeltrouble1 wrote: »Joe,
I need a lesson in this clamp.
RT1
Your hands are too big.:D -
WTH!!! I want one Joe....
