Concept 16.5 with SDAs
dcmeigs
Posts: 708
I have a Concept 16.5 in the house now that I'd like to audition with my SDA2Bs, however with it's dual mono design I'm reluctant to use it with the SDAs' interconnect. I'd need to strap the negative speaker terminals and I don't want to foul up the receiver.
The schematic shows internal grounding for the two negative terminals, so I suspect it should be OK, however the capacitors in series with the grounded terminals make no sense to me (to the point of my suspecting a drawing error). See the second page of the drawing for the speaker outs.
Does any one here have any practical experience with the Concept 16.5 in use with SDAs?
Thanks
The schematic shows internal grounding for the two negative terminals, so I suspect it should be OK, however the capacitors in series with the grounded terminals make no sense to me (to the point of my suspecting a drawing error). See the second page of the drawing for the speaker outs.
Does any one here have any practical experience with the Concept 16.5 in use with SDAs?
Thanks
The world is full of answers, some are right and some are wrong. - Neil Young
Post edited by dcmeigs on
Comments
-
I would say give it a try, starting at very low volumes and bring it slowly up to your mormal volume level. so long as the negative terminals are grounded together as you indicate there should be no troubles.The Gear... Carver "Statement" Mono-blocks, Mcintosh C2300 Arcam AVR20, Oppo UDP-203 4K Blu-ray player, Sony XBR70x850B 4k, Polk Audio Legend L800 with height modules, L400 Center Channel Polk audio AB800 "in-wall" surrounds. Marantz MM7025 stereo amp. Simaudio Moon 680d DSD
“When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson
