tweeter update for my rta12b's

chunny
chunny Posts: 15
edited February 2013 in DIY, Mods & Tweaks
Okay, my last post was going to another universe so to get back on track can any of you techno geeks tell me what mod's will be necessary to upgrade my RTA12 B's crossover and what speakers I shoud use for replacing the tweeter which has 5514stamped on the back? It looks like a black cloth dome with a vee shape groove on the front for the coil wires. Plus does anyone know what woofers I should order to replace the existing ones or if they work leave them alone?
Post edited by chunny on

Comments

  • Face
    Face Posts: 14,340
    edited April 2009
    That sounds like the "Peerless" tweeter, I would leave it alone. Same for the woofers.
    "He who fights with monsters should look to it that he himself does not become a monster. And when you gaze long into an abyss the abyss also gazes into you." Friedrich Nietzsche
  • chunny
    chunny Posts: 15
    edited April 2009
    Is there something special about the peerless tweeter that it's sound is superior to the replacement driver?
  • skspider
    skspider Posts: 14
    edited February 2013
    if drivers work, leave alone. as for cross over. recap. eliminate poly switch and silver mica caps.
    "Never underestimate the power of stupid people in large groups":rolleyes:
  • soundfreak1
    soundfreak1 Posts: 3,414
    edited February 2013
    There is a complete mod thread here (somewhere) on tje mod with a list of parts and caps. I will try to find it. If someone knows where it is please help out.
    Main Rig:
    Krell KAV 250a biamped to mid/highs
    Parasound HCA1500A biamped to lows
    Nakamichi EC100 Active xover
    MIT exp 1 ic's
    Perreaux SA33 class A preamp
    AQ kingcobra ic's
    OPPO 83 CDP
    Lehmann audio black cube SE phono pre, Audioquest phono wire (ITA1/1)
    Denon DP-1200 TT. AToc9ML MC cart.
    Monster HTS 3600 power conditioner
    ADS L1590/2 Biamped
    MIT exps2 speaker cable
  • drumminman
    drumminman Posts: 3,396
    edited February 2013
    Geoff727 did the best DIY write up for RTA 12's I've seen: http://www.polkaudio.com/forums/showthread.php?116480-RTA-12C-s-upgraded-for-forum-member-w-pics&highlight=geoff727

    Xover component values are in the schematics posted in one of the stickys. It's good policy to see what Polk actually used though, so check your caps and resistors for actual values.

    Good luck!
    "Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills/jantzen inductors, Gimpod's boards, Lg Solen SDA inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips, interior of cabinets sealed with Loctite Power Grab, AI-1 interface with 1000VA A-L transformer