Carver TFM-35 relisted with pictures...
nooshinjohn
Posts: 25,421
relisting My Carver TFM-35 two channel amp. newly replaced backlites for the watt meters. This amp is in excellent condition sonically, and performs better than my Sunfire does in stereo side by side tests... at least to my ear.
Cosmetics rate a conservative 6.5 as there are some very light scratches on the faceplace. Asking 325.00 shipped to the lower 48. I made this a new listing as pictures are attached this time...
FEATURES
Magnified Current technology for increasing voltage and current capability
Total Direct Coupling for high damping factor at all frequencies
Each channel protected by: individual fusing, excess temperature sense, DC fault sense, power-on delay, shorted load sense.
Minimal signal path design, with on card I/O connectors eliminating internal interconnect cables
Gold Plated RCA Jack Connections Dual analog lighted meters with range selection switch
Meter light On/Off switch
Individual calibrated level trim controls for each channel
Removable handles for 17" cabinet space (with trim caps)
Designed by Carver Corporation in Lynnwood, WA USA
TFM-35 SPECIFICATIONS
Frequency Repsonse: 20-20kHz +0,-0.2dB
Power Output: FTC 20hz-20khz
8ohm 250 watts per channel
4ohm 400 watts per channel
2ohm 750 watts per channel
Bridged mono power output: 800 watts into 8 ohms
THD: less than 0.08%
Dynamic Headroom: >1.0dB @ 8ohms both channels driven
Gain: 29.0 dB (+/- 0.5dB)
Input Impedance 47 kohms
Damping Factor: >150 typical (20hz-20 khz)
Cosmetics rate a conservative 6.5 as there are some very light scratches on the faceplace. Asking 325.00 shipped to the lower 48. I made this a new listing as pictures are attached this time...
FEATURES
Magnified Current technology for increasing voltage and current capability
Total Direct Coupling for high damping factor at all frequencies
Each channel protected by: individual fusing, excess temperature sense, DC fault sense, power-on delay, shorted load sense.
Minimal signal path design, with on card I/O connectors eliminating internal interconnect cables
Gold Plated RCA Jack Connections Dual analog lighted meters with range selection switch
Meter light On/Off switch
Individual calibrated level trim controls for each channel
Removable handles for 17" cabinet space (with trim caps)
Designed by Carver Corporation in Lynnwood, WA USA
TFM-35 SPECIFICATIONS
Frequency Repsonse: 20-20kHz +0,-0.2dB
Power Output: FTC 20hz-20khz
8ohm 250 watts per channel
4ohm 400 watts per channel
2ohm 750 watts per channel
Bridged mono power output: 800 watts into 8 ohms
THD: less than 0.08%
Dynamic Headroom: >1.0dB @ 8ohms both channels driven
Gain: 29.0 dB (+/- 0.5dB)
Input Impedance 47 kohms
Damping Factor: >150 typical (20hz-20 khz)
The Gear... Carver "Statement" Mono-blocks, Mcintosh C2300 Arcam AVR20, Oppo UDP-203 4K Blu-ray player, Sony XBR70x850B 4k, Polk Audio Legend L800 with height modules, L400 Center Channel Polk audio AB800 "in-wall" surrounds. Marantz MM7025 stereo amp. Simaudio Moon 680d DSD
“When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson
“When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson
Post edited by nooshinjohn on
Comments
-
sold to Intell99The Gear... Carver "Statement" Mono-blocks, Mcintosh C2300 Arcam AVR20, Oppo UDP-203 4K Blu-ray player, Sony XBR70x850B 4k, Polk Audio Legend L800 with height modules, L400 Center Channel Polk audio AB800 "in-wall" surrounds. Marantz MM7025 stereo amp. Simaudio Moon 680d DSD
“When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson -
Maybe I shouldn't bump this but I don't care! Just wanted to publicly thank you. Item was shipped immediately, packed extremely well, in excellent condition, and if it wasn't for UPS would have been here Friday. All hooked up now and loving it!!!!
I almost had to buy a new TV stand (had to take off the door to get it in!) cause I am not returning the Carver. Check out the crappy iPhone pics, my Nikon is dead.
Theater rig:
Pio Elite Pro 111-FD
Pio Elite VSX-01TXH
Mains: RTi12s
Center: CSi5
Surrounds: FXi3s, RTi6s
Sub: Velodyne V-1012-B
Amp: Carver TFM-35
Harmony 890
PS3
2-channel rig in progress:
LSi15s
......... -
Nice setup and Congrats.engtaz
I love how music can brighten up a bad day. -
looks great man.... I miss it alreadyThe Gear... Carver "Statement" Mono-blocks, Mcintosh C2300 Arcam AVR20, Oppo UDP-203 4K Blu-ray player, Sony XBR70x850B 4k, Polk Audio Legend L800 with height modules, L400 Center Channel Polk audio AB800 "in-wall" surrounds. Marantz MM7025 stereo amp. Simaudio Moon 680d DSD
“When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson