Velodyne VA-907 or CHT-10 and CSi3

Ender

Ok so here's a couple deals I found in my local CL.

Velodyne VA-907 for $150. May be able to haggle lower but no indication of it in the post.
Velodyne CHT-10 for $150-$190. Possibly may be able to haggle lower ($100-$125?).
Polk CSi3 for $75-$90. May be able to haggle lower (~$50).

What do you guys think? Any of these good deals?

I am leaning towards the CHT-10 for $150 or lower and the CSi3 for $50 if I could get it that low. Condition is unknown for these.

The VA-907 seems like a decent deal too. It appears to be in acceptable condition. I might try to haggle him down to at an initial go to $100.

http://losangeles.craigslist.org/sfv/ele/1076337457.html
http://losangeles.craigslist.org/sfv/ele/1074462716.html

macdaman

Ender, if you get the CSi3 for ~$50 is a great deal, you should go for it. I do not have any experience with Velodyne.

svtjoe

CHT-10 is a champ. I have a good sized room with tile, openings to the kitchen, hall and 10' Ceilings and it sounds great. I have had it for 7 years. There are times when it will overheat and shut off (Flip the switch to reset) and its back boomin again.

Very good value for HT.

I would like a 12' but they are still expensive being 6-8 years old!

Ender

Ok. Offered the one guy $200 for the CHT-10 and CSi3. Lol. We will see what he says.