what load would this be...?

Amit1591
Amit1591 Posts: 33
edited March 2009 in Car Audio & Electronics
What load would it be If i take my 2 Polk SR124dvc's set them both each to 2ohm settings and then connect the two positives and two negatives from each sub together into the amp...what would that result in and is it safe?
Post edited by Amit1591 on
· Share on FacebookShare on Twitter

Comments

  • hoosier21
    hoosier21 Posts: 4,413
    edited March 2009
    http://www.the12volt.com/caraudio/boxcalcs.asp
    Dodd - Battery Preamp
    Monarchy Audio SE100 Delux - mono power amps
    Sony DVP-NS999ES - SACD player
    ADS 1230 - Polk SDA 2B
    DIY Stereo Subwoofer towers w/(4) 12 drivers each
    Crown K1 - Subwoofer amp
    Outlaw ICBM - crossover
    Beringher BFD - sub eq

    Where is the remote? Where is the $%#$% remote!

    "I've always been mad, I know I've been mad, like the most of us have...very hard to explain why you're mad, even if you're not mad..."
    · Share on FacebookShare on Twitter
  • hoosier21
    hoosier21 Posts: 4,413
    edited March 2009
    http://www.soundkraft.com/Subwoofer_Wiring.htm
    Dodd - Battery Preamp
    Monarchy Audio SE100 Delux - mono power amps
    Sony DVP-NS999ES - SACD player
    ADS 1230 - Polk SDA 2B
    DIY Stereo Subwoofer towers w/(4) 12 drivers each
    Crown K1 - Subwoofer amp
    Outlaw ICBM - crossover
    Beringher BFD - sub eq

    Where is the remote? Where is the $%#$% remote!

    "I've always been mad, I know I've been mad, like the most of us have...very hard to explain why you're mad, even if you're not mad..."
    · Share on FacebookShare on Twitter
  • Amit1591
    Amit1591 Posts: 33
    edited March 2009
    Ok thanks... it would be a 1ohm load.
    · Share on FacebookShare on Twitter