RTIA1's can I remove...

DreamerPaul
DreamerPaul Posts: 4
edited February 2009 in DIY, Mods & Tweaks
Hey there I was wondering since I am not using the wall mounts on the RTIA1's, can I remove the wall mounts and rubber feet that keep the speaker off the wall. I want to do this since it is large and noticed but it looks as though it may serve some purpose for venting as well.

Thanks.
Post edited by DreamerPaul on
· Share on FacebookShare on Twitter

Comments

  • MattMF1
    MattMF1 Posts: 5
    edited February 2009
    that is the polk "power port". it is the tuned port that allows for low base notes to be produced my a speaker with fewer drivers.
    · Share on FacebookShare on Twitter
  • comfortablycurt
    comfortablycurt Posts: 6,745
    edited February 2009
    That's more than just a wall mounting plate...it serves as a power port. Removing it would change the sound quite a bit. I'd leave it on.
    The nirvana inducer-
    APC H10 Power Conditioner
    Marantz UD5005 universal player
    Parasound Halo P5 preamp
    Parasound HCA-1200II power amp
    PolkAudio LSi9's/PolkAudio SDA 2A's/PolkAudio Monitor 7A's
    Audioquest Speaker Cables and IC's
    · Share on FacebookShare on Twitter