is the top and bottom of lsi's paint or plastic

Flash!
Flash! Posts: 28
edited February 2009 in DIY, Mods & Tweaks
My LSI 9's have some scratches on top and bottom. If it is paint can i use some kind of scratch remover, or is the top and bottom plastic. If plastic, can the scratches still be taken off.
Post edited by Flash! on
· Share on FacebookShare on Twitter

Comments

  • steveinaz
    steveinaz Posts: 19,538
    edited February 2009
    You might try some Maquires "Scratch-X" on a scratch on the bottom as a test...I don't know if it's a laminate or some type of paint--I would quess it's a laminate.
    Source: Bluesound Node 2i - Preamp/DAC: Benchmark DAC2 DX - Amp: Parasound Halo A21 - Speakers: MartinLogan Motion 60XTi - Shop Rig: Yamaha A-S501 Integrated - Shop Spkrs: Elac Debut 2.0 B5.2
    · Share on FacebookShare on Twitter
  • MikeC78
    MikeC78 Posts: 2,315
    edited February 2009
    Depends on when they were made, the newer models are a laquer/paint type finish.
    · Share on FacebookShare on Twitter
  • Flash!
    Flash! Posts: 28
    edited February 2009
    how do i find out when these were made. I bought them used. Thanks for the Reply.
    · Share on FacebookShare on Twitter
  • treitz3
    treitz3 Posts: 19,135
    edited February 2009
    I would suggest contacting Polk CS during normal hours.
    ~ In search of accurate reproduction of music. Real sound is my reference and while perfection may not be attainable? If I chase it, I might just catch excellence. ~
    · Share on FacebookShare on Twitter