2 PolkSR124-dvc + 08 Kicker zx1000.1

Amit1591
Amit1591 Posts: 33
edited January 2009 in Basic Hookup/Wiring Questions
hey im new at this site and just had a couple of questions. i recently just purchased 2 polk sr124-dvc's and was wondering if i can wire them both at 2ohm loads each to my one 08 kicker zx1000.1 amp resulting in a 1ohm load. Would it be possible, im new at this and wasn't quite sure. I know the parallel wiring is capable resulting in a 4ohm load but then my amp would only be pushing out 500 watts to both subs put together. I want it to be 2ohms each so both of the subs get 500watts each instead of only 250watts each.
Post edited by Amit1591 on
· Share on FacebookShare on Twitter

Comments

  • wutadumsn23
    wutadumsn23 Posts: 3,702
    edited January 2009
    Welcome to Club Polk Amit, you might get more/better results from our "Car Guys" in the car audio section of the forum.
    HT Rig
    Receiver- Onkyo TX-SR806
    Mains- Polk Audio Monitor 70
    Center- Polk Audio CS2
    Surrounds- Polk Audio TSi 500's :D
    Sub- Polk Audio PSW125
    Retired- Polk Audio Monitor 40's
    T.V.- 60" Sony SXRD KDS-60A2000 LCoS
    Blu-Ray- 80 GB PS3


    2 CH rig (in progress)
    Polk Audio Monitor 10A's :cool:

    It's not that I'm insensitive, I just don't care.. :D
    · Share on FacebookShare on Twitter
  • Amit1591
    Amit1591 Posts: 33
    edited January 2009
    OO alrite thanxx soo i shud post this up in their sectionn??
    · Share on FacebookShare on Twitter