wiring mishap

richta
richta Posts: 26
edited January 2009 in Basic Hookup/Wiring Questions
I am attempting to replace the binding posts on a set of SDA 2s.
While doing do I damaged one of the black wires.It's about ten inches coupled together by a ring terminal with another piece five inches.The other end of the ten inch section has a female disconnect either 1/8" or 3/32.
Any suggestions for replacement?
I spent the better part of today searching for that disconnect locally to no avail.
Thanks in advance.

RT
Post edited by richta on
· Share on FacebookShare on Twitter

Comments

  • treitz3
    treitz3 Posts: 19,190
    edited January 2009
    Try Parts Express or just solder directly onto the post.
    ~ In search of accurate reproduction of music. Real sound is my reference and while perfection may not be attainable? If I chase it, I might just catch excellence. ~
    · Share on FacebookShare on Twitter
  • richta
    richta Posts: 26
    edited January 2009
    Any guesses as to what kind of wire to purchase?
    · Share on FacebookShare on Twitter
  • comfortablycurt
    comfortablycurt Posts: 6,745
    edited January 2009
    richta wrote: »
    Any guesses as to what kind of wire to purchase?

    I'm not an expert, but I'd imagine regular speaker wire would be fine. Keep it the same gauge as original, and get some decent wire and you should be fine.
    The nirvana inducer-
    APC H10 Power Conditioner
    Marantz UD5005 universal player
    Parasound Halo P5 preamp
    Parasound HCA-1200II power amp
    PolkAudio LSi9's/PolkAudio SDA 2A's/PolkAudio Monitor 7A's
    Audioquest Speaker Cables and IC's
    · Share on FacebookShare on Twitter