Bi-amping CS400
gene stangel
Posts: 35
I recently bi-amped my CS400 center channel in an attempt to smooth out some sharp treble ( I think that the amp is still breaking in). I ran the center channel amp from an Acurus 200 watt to the mids and the output from a Marantz MA500 monoblock also powering a CS350 in parallel. So the Marantz is seeing a 4 ohm load and the Acurus I believe an 8 ohm load.
Anyone see any problem with the hookup or an I sending too much juice to the speaker. Thanks.
Anyone see any problem with the hookup or an I sending too much juice to the speaker. Thanks.
Post edited by gene stangel on
Comments
-
Originally posted by gene stangel
I ran the center channel amp from an Acurus 200 watt to the mids and the output from a Marantz MA500 monoblock also powering a CS350 in parallel.
What?
Break it down, input to output.
Cheers,
RoosterCheck your lips at the door woman. Shake your hips like battleships. Yeah, all the white girls trip when I sing at Sunday service. -
Lost here also.
-
Do we make things more complicated then they should be sometimes?? I wonderMY HT RIG:
Sherwood p-965
Sherwood sd871 dvd
Rotel 1075 amp x5
LSI15 mains
LsiC center
LSIfx surround backs
Lsi7 side surrounds
SVS pb12/plus2
2 Channel Rig:
nad 1020 Pre-amp
Rotel 1080 stereo amp
Polk sda 2B
kenwood grunt Tuner
realistic lab 450 TT
Signal cable IC -
MA500 - to single set of inputs on CS350, then wire from CS350 to
Tweeter on CS400.
Acurus - To Mid input on CS400.
I did this because the Marantz seemed smoother on the treble.
Thanks for your interest.