Crossover setup for RTi12, CSi6, F/Xi6, Sub

pargol4
pargol4 Posts: 1
edited December 2008 in Basic Hookup/Wiring Questions
I have the following setup:
Pre-Amp: JBL Performance AV1
Amp: JBL Performance AVA7
Front: RTi12
Center: CSi6
Surround: F/XiA6
Sub: Kilpsch SW12 (circ. 1994)

I can set individual Crossover Frequencies for each speaker, from 30-120hz in 10hz increments, FULL, or NONE.

A THX setup on the pre-amp sets all of them to 80hz. From what I have read, the Polk speakers are not THX certified.

Any help would be appreciated.
Post edited by pargol4 on
· Share on FacebookShare on Twitter

Comments

  • leroyjr1
    leroyjr1 Posts: 8,785
    edited December 2008
    Normally I would set all of them at 80hz and let your sub handle the rest but since you have the RTI 12's I would set them a little lower. I would even try full range and see how that sounds. Everyone has different opinions on this matter. Play around with the setting and see what sounds best.

    My setup

    RTI A9 = full range
    RTI A5 = 80HZ
    CSI A6 = 80HZ
    FXI A6 = 80HZ

    SUB = 80HZ
    · Share on FacebookShare on Twitter
  • Mike Reeter
    Mike Reeter Posts: 4,315
    edited December 2008
    I have my 12's set to LARGE and the x-over set at 60 hz...everything else set to SMALL.

    THX certifcation doesn't mean ****.
    · Share on FacebookShare on Twitter