amp/sub question
ROOGER82
Posts: 30
OK so i ordered a set of 10" DVC momo subs....but they had sent me the new DB subs. Called polk and they told me the Momo line is being replaced so those subs were the closest matching to the ones i ordered.
After getting refunded the difference. I now have a PA600.1 and 2 DB subs.
My problem is that the DB subs run at 250W RMS....and the amp i will be using runs at 600W...because i am bridging down to 1 ohm.
Is this too much for the subs?. Any suggestions on what I should do?
this is the last part of my audio system i need to finish...well besides putting the radio in.
After getting refunded the difference. I now have a PA600.1 and 2 DB subs.
My problem is that the DB subs run at 250W RMS....and the amp i will be using runs at 600W...because i am bridging down to 1 ohm.
Is this too much for the subs?. Any suggestions on what I should do?
this is the last part of my audio system i need to finish...well besides putting the radio in.
(Insert clever sig here);)
Post edited by ROOGER82 on
Comments
-
Where did you order them from?
-CodyMusic is like candy, you have to get rid of the rappers to enjoy it -
i ordered them form my polk audio accomodations from Circuit City. and there is a no return policy.
I have no problem with the mix up....just hoping i dont blow the subs.(Insert clever sig here);) -
Did they give you any money back?
You have 500w worth of subs on a 600w amp, you should be okay.
-CodyMusic is like candy, you have to get rid of the rappers to enjoy it -
ya they did give me money back....One more question.
I am currently running the DB series components and the 6x9's. For the meantime untill i get the dough to get my doors fiberglassed I will be using those. Will the PA500.4 be too much power?
I have never overpowered speakers before...just subs...so I dont know how these will be affected.(Insert clever sig here);) -
ok so my trunk set up is done...will try and post pics tomorrow so u guys can judge it.(Insert clever sig here);)
