subwoofer wiring help

thumpin07

I have a fusion EN-AM8001 Encounter Monoblock Amplifier, the spec are as follows:
Product Specifications

262 Watts RMS x 1 Channel @ 4 Ohms and 1% THD+N
368 Watts RMS x 1 Channel @ 2 Ohms and 1% THD+N

Max Power Rating: 800 Watts
THD @ Rated Power 1kHz/100Hz: 0.1%
Frequency Response Hz (-3dB): 10Hz - 250Hz
Signal to Noise: >90
Variable Low Pass Filter: 6dB/Octave
Bass Boost @ 45Hz: 0dB/6dB/12dB
Input Sensitivity: 0.2-8V
Input Impedance: 20K
Fuse Rating: 25A x 2

It is a 2ohm stable amp, my guestion is how do i wire my sub to be 2ohm stable?
The specs for the sub are as follows:

It is a Volfenhag zx-4712 1000w max 4ohm + 4ohm dual voice coil usable impedence is 2-8 ohm. How do i wire this thing at 2 ohm stable?

If i can wire my sub 2 ohm stable ill get more rms out of my amp

tyler

Jstas

You don't have to post the same post in two different forums. If you are too impatient to wait until someone sees your post and has an opportunity to respond then you will be sorely disappointed in your endeavors here at Club Polk.

thumpin07

it was not that i was being impatient it was the fact i wasnt sure if i posted it in the right part of the forum. I apoligize for double posting, but i was just unsure where to put it, i apoligize.

thumpin07

I just dont understand how to wire it 2 ohm stable is all