Cross over settings?

DannyD

Can someone please help me with my cross settings for the speakers you see in my signature. I'm not sure what they should. I ran the ez setup mic that came with my HK247 but It changes everytime I run the setup. I currently have my RTI10 set to 40hz along with all the other speakers. Judging from what I've been reading in the forum this doesn't seem correct. Please advise.

tonyb

Oh Danny Boy,are your speakers hooked up to the receiver or the sub?I'm guessing the receiver,try them at around 70.Sub connected to sub out on the receiver?

DannyD

My speaks are connectd to the reciever and the sub to he sub out like you said. Should I set them all to 70?

tonyb

No,the front left and rightYou have the fronts set to large right?center small or large? Surrounds small? Crossover on the back of the sub should be turned all the way up.

tonyb

Maybe your avr won't let you do that,set them all around 70 to start.

jakelm

Danny, reset the HK. Run the ezeq again, see where it sets the xovers. The change the xovers to what you want and re-run the ezeq again in manual mode. You shout be good like that...

Make sure your mic is close to where you sit, maybe center of room no less that 3 feet off ground, and do the near field too.

tonyb

Thats probably his problem,where he has the mic.

jakelm

My HK does an great job at eq'ing. Doesnt quite set the xovers where I like, but does a good job with everythiing else

DannyD

Thanks guys