Amp question

Systems
Systems Posts: 14,873
edited October 2002 in Car Audio & Electronics
Can anyone tell me if the jl 300/4 amp would be enough to power two sets of the mm6 components and if not what other amps would you reccomend? thanks
Testing
Testing
Testing
Post edited by Unknown User on
· Share on FacebookShare on Twitter

Comments

  • Thom
    Thom Posts: 723
    edited October 2002
    I think that amp is rated at 75 watts x 4; if so that will be fine.
    · Share on FacebookShare on Twitter
  • PoweredByDodge
    PoweredByDodge Posts: 4,185
    edited October 2002
    i'm not sure how a bridge would work on a regulated amp, but if you already have the 300/4 and dont want to just scrap it, you could try briding it and running just 1 set of comps off it... 75x3 = 220 by 2 ... keep the gains down (if u've got a 2 vrms preout - about 30% would do) and those 6.5 components should scream -- i do about 140-150 x 2 on my fronts off two 180/1 amps, and it's a helluva improvement over the 65 by 2 i used to run.

    however kim is right in the long run -- a 'true' 150 x 2 amp would be better than underpowering or bridging a weaker amp up to it... it keeps the thd down, and the device is then working within its means.

    g'luck. :)
    The Artist formerly known as PoweredByDodge
    · Share on FacebookShare on Twitter