nOOb question about c300.2

_mo_
_mo_ Posts: 53
edited September 2007 in Car Subwoofer Talk
Hey folks,

I did a bad thing and got a used c300.2 off of Ebay w/out doing all my research. I got a great deal, mind you, just shouldn't have impulse bought.

Anyway, I'm getting some mixed messages from the forums about the ability of this amp to power 2 polk/momo 10 inch subs. Am I right that if I get two of the MM2104DVC's and then bridge the AMP and wire the coils in series and the speakers in parallel, like this, that it should work well?

Thanks for the help
Family Room 7.2.4: S35, S60, S10, MM2104 endtables, TL1
Basement 5.1.2: CS400i, RT55i, RT25, PSW450, MC60
Living Room Stereo: SDA 2a
Post edited by _mo_ on
· Share on FacebookShare on Twitter

Comments

  • MacLeod
    MacLeod Posts: 14,358
    edited September 2007
    Right.

    A pair of DVC subs would be 2 ohms wired in parallel or 8 ohms wired in series.

    Wire both subs in series for an 8 ohm load per sub and then both subs wired in parallel to the amp for a 4 ohm mono load. That is well within the operating range of the 300.2
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
    · Share on FacebookShare on Twitter
  • _mo_
    _mo_ Posts: 53
    edited September 2007
    That's what I figured. Thanks a lot Mac!
    Family Room 7.2.4: S35, S60, S10, MM2104 endtables, TL1
    Basement 5.1.2: CS400i, RT55i, RT25, PSW450, MC60
    Living Room Stereo: SDA 2a
    · Share on FacebookShare on Twitter