GNX 124 box plan????
thoffmann
Posts: 3
Has anybody used the GNX124 in a bandpass??? I don't have monster power but I want to feel the bass like I had 1000 watts going to them. I have 2 GNX124's and a 400 watt amp to push them. Ideas anybody???
Thanks
Thanks
Post edited by thoffmann on
Comments
-
I am unable to load the attachment you sent. Something about my graphics conversion filter??? is there a web address that I can go to??? or could you e-mail me the info in a different form???? I would really like to see this box design, as you have my full attention
Thanks
thoffmann -
Would it be possible to have 1 six inch port instead of 2 4 inch ports? If so how long would the 6 inch port need to be???
Thanks
thoffmann
-
Kim wrote:then this will tune the enclosure to 54 Hertz and the vent air velocity will be a little lower. ...
The two 4 inch diameter ports, 12 inches in length will tune the enclosure to 52.9 Hertz
anytime anybody **** about current model polk stuff - they should be shot in the foot and then made to read the above post and realize the error of their ways.
"we've come a long way baby".
the new DB12 slot port box by polk plays (on paper) down to 27 hertz - even if you play devil's advocate and throw a little fudge in there - call it 30 hertz - you're still in "happy bass land" - still in kicking **** territory... a 50-something hertz resonant box frequency for the above mentioned GNX's is utterly sickening.
why am i reading old posts? i dunno - its 1:15 in the morning and i'm tired.The Artist formerly known as PoweredByDodge -
....memories...Picking ones nose signifies a strong sense of self discovery
System in the works:
PP 6V6 with 12ax7 pre ~ 20 watts
15" Jensen MOD 8ohm ~ 97db SPL
DiMarzio HS3 and/or Tone Zone S