1 amp running 2 component sets???

lowrike
lowrike Posts: 3
edited July 2007 in Car Audio & Electronics
Can anybody advise me on weather or not I can run 2 MMC 6500 component sets off a 4 channel amp? I was hoping to run 1 tweeter and 1 mid off of each channel. The amp is a Kicker KX850.4 (175x4 RMS). Thanks for any info you may have.
Post edited by lowrike on
· Share on FacebookShare on Twitter

Comments

  • killerb
    killerb Posts: 390
    edited July 2007
    yes you can.
    kenwood excelon kdc-x991 h.u.
    Rockford Fosgate 360.3 DSP
    Rockford Fosgate POWER1000 running entire system
    Image Dynamics IDQ12 Sub
    Morel Elate 6 front stage
    · Share on FacebookShare on Twitter
  • eloplayspolo
    eloplayspolo Posts: 1,117
    edited July 2007
    the crossover has directions to do so directly on the crossover, u go amp to tweater in, and then connect the speakers just like it says i belive.
    2013 Toyota Prius
    Audible Physics 3 Way: H6MB, AR3-A, AR2.0
    Image Dynamics iDMax 12" D2v4
    (2) Alpine PDX-V9 Bridged, Alpine PDX-M12 (500w Mid-Bass, 200w Mid, 200w Tweet, 1200w Sub)
    Mosconi 6to8 v8
    · Share on FacebookShare on Twitter
  • lowrike
    lowrike Posts: 3
    edited July 2007
    Ok..I'm in single mode on the crossover and when I use the tweeter (in) to the amp I only get sound out of the tweeters. What am i missing? Thank you for your replies.
    · Share on FacebookShare on Twitter
  • lowrike
    lowrike Posts: 3
    edited July 2007
    got it, thanks!
    · Share on FacebookShare on Twitter