Remote problems with new Plasma

janmike
janmike Posts: 6,146
edited May 2007 in Electronics
Well the new Plasma (Panasonic TH-50PX75U) arrived the other day and everything is awesome. All except the remote for the Proceed AVP-S that I am using to drive my HT (controls sound level and sound mode). The minute I turn on the Plasma, the remote stops working. Batteries are ok and I can even be in 2CH music and the remote works with the Plasma turned off. Turn of the Plasma and the remote stops. Sounds like I am getting some kind of interference. I have e-mailed both Panasonic & the Harman Specialty Group to see what they have to say, but with any troubleshooting with different components I can bet there will be a lot of finger pointing. Just wondered what you folks thought. Thanks and yes I need a single point of contact for the remote. The Harmony 1000 is in the works.
Michael ;)
In the beginning, all knowledge was new!
NORTH of 60°
Post edited by janmike on
· Share on FacebookShare on Twitter

Comments

  • janmike
    janmike Posts: 6,146
    edited April 2007
    I received a reply back from the Harman Group and they indicated that this is quite common with plasma TV's. Their suggestion was to move the AVP further away from the plasma. Right! :rolleyes:
    Michael ;)
    In the beginning, all knowledge was new!
    NORTH of 60°
    · Share on FacebookShare on Twitter
  • janmike
    janmike Posts: 6,146
    edited May 2007
    Just purchased a new Harmony 1000 for my HT. Just could not handle the multiple remote thing anymore.
    Michael ;)
    In the beginning, all knowledge was new!
    NORTH of 60°
    · Share on FacebookShare on Twitter
  • Systems
    Systems Posts: 14,873
    edited May 2007
    Awesome remote.I wish I had the budget for one of those little beauties.
    Testing
    Testing
    Testing
    · Share on FacebookShare on Twitter