Bi-Amping db6500

rodney
rodney Posts: 91
edited April 2007 in Car Audio & Electronics
OK, I'm going to use a profile ap1040, rated at 80x4 rms, to bi-amp my polk db6500 components (getting rid of my rear 6x9s). Should I just run the 6.5 woofer on full range, or should I use the filters on the amp? The tweeters will still be going through the crossover.

thanks
alpine cda-9857
polk db6500
polk ex369
polk/momo mm104
profile ap1040
kenwood kac-7251
· Share on FacebookShare on Twitter

Comments

  • MacLeod
    MacLeod Posts: 14,358
    edited April 2007
    You can run the mid full range. However if the amp has a low pass filter thatll go high enough like 3-5 KHz you can fiddle with it and see if you like it.
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
    · Share on FacebookShare on Twitter