speaker height
comet91
Posts: 56
should your speakers be tweeters be at ear level when you sit in the sweet spot. if they what could you use to bring them up to that height.
Post edited by comet91 on
Comments
-
Yes. I don't know, speaker stands maybe.
What speakers are you using?Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Definitely speaker stands.
General rule is ear level. I personally have found that a little above ear level gives a more open effect yet slightly below ear level makes for a more coherent sound stage.
Just experiment and go with what your prefer.HT
Mits WD-65737, DirecTV, Oppo DV-970HD, XBOX ONE, Yamaha RX-A1030, Parasound Halo A23, Rotel RB-985, Music Hall MMF-7, Parasound PPH-100, LSi-15, LSi-C, LSi-FX, LSi-7, PSW-1000, Monster HTS2600
2 CH
Parasound Halo P3, Parasound Halo A21, Sutherland Ph.D, VPI Classic 3 w/ 3D arm & Soundsmith Aida Cartridge, Arcam CD72T, B&W 802 S3, Monster HTS2500, -
I like the middle of the speaker to be ear level. I believe that's how most manufacturer's envision their position and thus their design.Carl
-
Bose lifestyle.hmm more like impotent.........just a side thought lol:)Chicomorales:)
-
Sit on some phone books first to see if you like the sound you get. If you like it, then go with speaker stands.
-
the speakers are linn keilidh they are 2' 8" high
-
If you can't bring them up try tilting the front end up an inch or two.The tweeter at ear level thing is a general rule,not in stone.I enjoy sitting on the floor the best.HT SYSTEM-
Sony 850c 4k
Pioneer elite vhx 21
Sony 4k BRP
SVS SB-2000
Polk Sig. 20's
Polk FX500 surrounds
Cables-
Acoustic zen Satori speaker cables
Acoustic zen Matrix 2 IC's
Wireworld eclipse 7 ic's
Audio metallurgy ga-o digital cable
Kitchen
Sonos zp90
Grant Fidelity tube dac
B&k 1420
lsi 9's -
A couple of empty beer cases stacked up should give you the height you need. Start with PBR and if you don't like the sound try Bud or something
-
i might try some 7" stands with a 3 degree tilt, works great for the older Polk Monitors and will give you a bit of a poor mans real time alignment.
Doro has an old thread if you search on how to build some.
RT1