Polk Audio RTi6 Speakers

ferdelance1
ferdelance1 Posts: 7
edited January 2007 in Speakers
I just purchased four (4) each 8 Ohm RTi6 Speakers to add to my assortment of speakers ect. I know this is a very dumb sounding question, but would someone please clue me in on how one tells the right speaker from the left? My LSi9 speakers are clearly marked, however, I don't see any markings whatsoever on the RTi6 speakers other than the RTi6 and serial numbers.

PLease advise:

Derek K.
Post edited by ferdelance1 on
· Share on FacebookShare on Twitter

Comments

  • VR3
    VR3 Posts: 28,791
    edited January 2007
    dosnt matter
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • danger boy
    danger boy Posts: 15,722
    edited January 2007
    for the RTi6's.. there is NO left or right speaker.. so it doesn't matter if they are in either position. enjoy. and rock on...
    PolkFest 2012, who's going>?
    Vancouver, Canada Sept 30th, 2012 - Madonna concert :cheesygrin:
    · Share on FacebookShare on Twitter
  • beardog03
    beardog03 Posts: 5,550
    edited January 2007
    one goes on the port side ...one starboard

    doesn`t matter which one...
    Cary SLP-98L F1 DC Pre Amp (Jag Blue)
    Parasound HCA-3500
    Cary Audio V12 amp (Jag Red)
    Polk Audio Xm Reciever (Autographed by THE MAN Himself) :cool:
    Magnum Dynalab MD-102 Analog Tuna
    Jolida JD-100 CDP
    Polk Audio LSi9 Speaks (ebony)
    SVS PC-Ultra Sub
    AQ Bedrock Speaker Cables (Bi-Wired)
    MIT Shotgun S1 I/C`s
    AQ Black Thunder Sub Cables
    PS Audio Plus Power Cords
    Magnum Dynalab ST-2 FM Antenna
    Sanus Cherry wood Speak Stands
    Adona AV45CS3 / 3 Tier Rack (Black /Gold)

    :cool:
    · Share on FacebookShare on Twitter
  • ferdelance1
    ferdelance1 Posts: 7
    edited January 2007
    Thank you all so much for answering my dumb question ! ! !

    Derek K. :)
    · Share on FacebookShare on Twitter
  • schwarcw
    schwarcw Posts: 7,341
    edited January 2007
    Nothing dumb about asking, thanks for stopping by!:)
    Carl

    · Share on FacebookShare on Twitter
  • shack
    shack Posts: 11,154
    edited January 2007
    The LSi9s are asymmetrical therefore L & R needs to be defined based on design parameters. The RTi6s are symmetrical so it doesn't matter.
    "Just because you’re offended doesn’t mean you’re right." - Ricky Gervais

    "For those who believe, no proof is necessary. For those who don't believe, no proof is possible." - Stuart Chase

    "Consistency requires you to be as ignorant today as you were a year ago." - Bernard Berenson
    · Share on FacebookShare on Twitter