SRS 2.3's Sound Levels

westdr1
westdr1 Posts: 12
edited December 2006 in Vintage Speakers
I have a pair of the 2.3's that I have finally been able to put back into action today after replacing the amp. I bought the NAD C272. I noticed the sound on the right channel to be substanially muffled in comparsion to the left. It does not appear to be distorted and I am unable to see any physical damage on any of the speakers. I noticed there were some problems mentioned on the polyswitchs. Is this characteristic of the polyswitch.

I am in the process of rebuilding the cross overs.

Any speaker cable recommendations would be appreciated. I am currently using Monster that I bought when the speakers were new.

TIA
Post edited by westdr1 on
· Share on FacebookShare on Twitter

Comments

  • george daniel
    george daniel Posts: 12,096
    edited December 2006
    Assuming that you have ruled out the amp as the problem,the poly's are for tweeter protection and usually reset,check your source,cables,etc. Good luck
    JC approves....he told me so. (F-1 nut)
    · Share on FacebookShare on Twitter
  • westdr1
    westdr1 Posts: 12
    edited December 2006
    george daniel wrote:
    Assuming that you have ruled out the amp as the problem,the poly's are for tweeter protection and usually reset,check your source,cables,etc. Good luck


    George;

    Thanks I will check them.
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,731
    edited December 2006
    I've heard others report the same issue, but I can't recall anyone posting a solution other than placement issues. Can you give us a description with measurements of your layout?
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter