NAD T743 vs NAD 7600
I'm looking at an auction for these 2, which of these 2 can effectively handle 5 polk audio speakers lci series with 4 omh load. I plan on using amp with at least 200wpc but don't know which. I plan to use sub psw505. Will this work? The nad 7600 auction states,"170 WATTS PER CHANNEL INTO 8 OHMS! IT CAN HANDLE ALMOST ANY LOADS DOWN TO 2 OHMS,WHERE IT CAN CREATE DYNAMIC OUTPUTS OF 0VER 800 WATTS ! IN BRIDGED MODE,DYNAMIC POWER INTO 4 OHMS IS AN ASTOUNDING 1400 WATTS!" How does this bridged mode work and is it effective?
Post edited by rrage on
Comments
-
The NAD 7600 is a 2 channel (stereo) receiver. Uses the 2600A amplifier section.
http://207.228.230.231/info/NAD_7600.pdf
Not the right product for HT. The T743 is what you need.Signature goes here -
thanks. any info about bridged mode and how that works.
-
Might want to keep this one in mind as well. (no affiliation, just wanted you to be aware of it....)
MichaelMains.............Polk LSi15 (Cherry)
Center............Polk LSiC (Crossover upgraded)
Surrounds.......Polk LSi7 (Gloss Black - wood sides removed and crossovers upgraded)
Subwoofers.....SVS 25-31 CS+ and PC+ (both 20hz tune)
Pre\Pro...........NAD T163 (Modded with LM4562 opamps)
Amplifier.........Cinepro 3k6 (6-channel, 500wpc@4ohms) -
You can bridge the 7600 so that it is just a one channel mono amp.Signature goes here
