Binding Post Specifications on RT12

dhelvie
dhelvie Posts: 2
edited October 2006 in Basic Hookup/Wiring Questions
Hello everyone,

This is my first post to the group, I have a set of RTI 12's.
I am about to buy some cables for these speakers.
I know I don't want banana's, I'd prefer spades but what size?

There is no reference to the binding post specifications. Does anyone know? 3/8? 5/16?

I just bought a Bryston 4B on Ebay:) and I am going to change to a single amp configuration (I hope) is the reason I ask.

I want to make sure the spade ends fit perfectly on both ends.

Is anyone esle running a 4B with these Polks? Comments welcome.

Thanks for reading my post.
Dan Helvie
Jax, Fl.

My setup consists of:
Amp1: Carver TFM45 (Bi wired for the bass)
Amp2: SAE A502 (Mids and highs)
Premp:Cambridge C500
Sub: Polk PSW10
Speakers: Polk RTI12
Post edited by dhelvie on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,665
    edited October 2006
    Welcome!

    Can you not measure the posts yourself?
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • dhelvie
    dhelvie Posts: 2
    edited October 2006
    heheheee, yeah I certainly could do that.
    I was just wanting to create some discussion about it.
    Thanks; Dan
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,665
    edited October 2006
    Well in that case, I prefer bananas.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter