will this amp work with my MMC690s

seth2367
seth2367 Posts: 2
edited September 2006 in Car Audio & Electronics
Hi,

i recently bought some MMC690 4ohm 100wattRMS and 300wattpeak speakers...


I have a (KAC-7201) 2 channel kenwood 150wattRMSx2 @4ohm and 800watt peak.

would it be a good idea to wire the amp to the speakers??

or would i blow them up...

I'm kind of sad because i have this amp sitting around, and i want to use it!! ahh.... if it doesn't work then i'll trade with a lower RMS amp!


but the main question.... can i hook that amp up to my speakers and not harm them?
Post edited by seth2367 on
· Share on FacebookShare on Twitter

Comments

  • MacLeod
    MacLeod Posts: 14,358
    edited September 2006
    Yes, that amp will work fine.

    Make sure you dont set the gain too high and if the speakers sound like theyre being pushed too hard, they are. Back off the gain some more. But with proper settings and common sense with the volume knob, this amp will run the 690's just fine.
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
    · Share on FacebookShare on Twitter