Amp in a Jeep
xshark_bait_13x
Posts: 1
This may seem a little strange but I wanted to know if there was any way to make some sort of water-resistant casing for an amp. I was thinking about getting the Polk C400.4 but I have a Jeep Wrangler that gets wet from time to time. I didn't want to spend the money on something that will probably break from water damage down the road -Thanks
Post edited by xshark_bait_13x on
Comments
-
the problem with the water resistant bit is that an airtight casing will generally destroy the amp's ability to dissipate heat... if you can fabricate, say, an aluminium box and figure out a way to couple the amp's casing to the box, you'll get your watertightness and still retain heat dissipation... simply sticking it in a tupperware box, however, will not cut it...
can you work with that?It's not good, very fundamentally simply not good. - geolemon
"Its not good enough until we have real-time fearmongering. I want my fear mongered as it happens." - Shizelbs -
Hmm, that would be tough. At one time I was contemplating making a wooden enclosure for amps in my Cherokee. I was going to make the top hinge so I could access the amp(s), and I was going to mount a few computer fans on one side of the box. That way the amp(s) would still get sufficient ventilation, and for all practicaly purposes it would be water tight, depending on just how wet your Jeep gets. Of course, I was also going to wrap the box in carpet.
Perhaps something like this would work.George Grand wrote: »
PS3, Yamaha CDR-HD1300, Plex, Amazon Fire TV Gen 2
Pioneer Elite VSX-52, Parasound HCA-1000A
Klipsch RF-82ii, RC-62ii, RS-42ii, RW-10d
Epson 8700UB
In Storage
[Home Audio]
Rotel RCD-02, Yamaha KX-W900U, Sony ST-S500ES, Denon DP-7F
Pro-Ject Phono Box MKII, Parasound P/HP-850, ASL Wave 20 monoblocks
Klipsch RF-35, RB-51ii
[Car Audio]
Pioneer Premier DEH-P860MP, Memphis 16-MCA3004, Boston Acoustic RC520 -
I built a flat plate and mounted it under the passenger seat - (you have to remove the seat and measure carefully) then insulated it from the tub by rubber grommets (which also helps with vibration). This isn't waterproof but it protects the amp from casual splash and rain and keeps it out of the way. Chase your wires along the floor boards and kick panels (this was in 93YJ by the way). Use quick disconnects for any door speaks so you can still go naked without your doors (or change to half, etc.)VA HT HK AVR20II, Sony S9000ES CD/DVD/SACD, Polk Audio RC80i / Polk Audio CSi3, 60" Panasonic Plasma, Nordost / Signal Cable A2 / Wireworld / Pangea / Magic Power
VA 2 Channel Focal Electra 926 speakers, Pass Labs X150.5 Amp, Eastern Electric MiniMax Preamp (Tutay mods), Eastern Electric Minimax CDP (Scott Nixon mods), Music Hall mmf 5.1 Turntable, Parks Audio Budgie Phono Pre , Audioengine B1 streamer, MIT S3 IC's / MIT Shotgun S3 Speaker Cables / PS Audio power cables
Noggin Schiit Valhalla, Pangea, Phillips Fidelio X1, Polk UF8000
Polk SDA1c modded
Polk CRS+ 4.1TL modded (need veneer)
Polk SDA2BTL (fully modded)
A/L 1000VA Dreadnought Canare 4s11 SDA cable
SACD Marantz DV8300
Sony S9000ES CD/DVD/SACD
Yamaha YP-D6
Soundcraftsmen PCR800
Audible Illusions L1 Preamp
Vincent MFA based Cocci Tube Preamp
Pho-700 Phono Pre
Signal Cable Silver Resolution IC's -
I just realized something.
"Shark Bait Ooo HaHa"
George Grand wrote: »
PS3, Yamaha CDR-HD1300, Plex, Amazon Fire TV Gen 2
Pioneer Elite VSX-52, Parasound HCA-1000A
Klipsch RF-82ii, RC-62ii, RS-42ii, RW-10d
Epson 8700UB
In Storage
[Home Audio]
Rotel RCD-02, Yamaha KX-W900U, Sony ST-S500ES, Denon DP-7F
Pro-Ject Phono Box MKII, Parasound P/HP-850, ASL Wave 20 monoblocks
Klipsch RF-35, RB-51ii
[Car Audio]
Pioneer Premier DEH-P860MP, Memphis 16-MCA3004, Boston Acoustic RC520 -
audiobliss wrote:I just realized something.
"Shark Bait Ooo HaHa"It's not good, very fundamentally simply not good. - geolemon
"Its not good enough until we have real-time fearmongering. I want my fear mongered as it happens." - Shizelbs -
neomagus00 wrote:(my windows startup sound is a techno remix of the seagulls )
George Grand wrote: »
PS3, Yamaha CDR-HD1300, Plex, Amazon Fire TV Gen 2
Pioneer Elite VSX-52, Parasound HCA-1000A
Klipsch RF-82ii, RC-62ii, RS-42ii, RW-10d
Epson 8700UB
In Storage
[Home Audio]
Rotel RCD-02, Yamaha KX-W900U, Sony ST-S500ES, Denon DP-7F
Pro-Ject Phono Box MKII, Parasound P/HP-850, ASL Wave 20 monoblocks
Klipsch RF-35, RB-51ii
[Car Audio]
Pioneer Premier DEH-P860MP, Memphis 16-MCA3004, Boston Acoustic RC520 -
i made like a 20 sec clip, but it's still a work in progress... when i finish it, i'll make sure you get to hear itIt's not good, very fundamentally simply not good. - geolemon
"Its not good enough until we have real-time fearmongering. I want my fear mongered as it happens." - Shizelbs